Pages

Wednesday, March 22, 2017

Circuit Schematic Diagram Electronics Motor Controller Based on Transistor

ElcoHow. - This is one circuit schematic diagram of Electronics Motor Controller Based on Transistor that very useful for you who want to build motor controller easily in this time.

In this time, we will give you global description about this Electronics Motor Controller Based on Transistor like in Figure 1 below, beside we give you circuit schematic diagram and component parts used in this circuit.

Circuit Schematic Diagram

Component Parts


  1. R1 = 150 KΩ
  2. R2 = 33 KΩ
  3. R3 = 6.7 KΩ
  4. R4 = 100 KΩ
  5. R5 = 39 KΩ
  6. R6 = 15 KΩ
  7. R7 = 10 KΩ
  8. R8 = 4.7 KΩ
  9. R9 = 75 Ω/1W
  10. R10, R13 = 47 KΩ
  11. R11 = 470 Ω
  12. R12 = 0.5 Ω
  13. VR1 = 2.2 KΩ
  14. C1 = 1000 µF/25V
  15. C2, C3 = 47 µF/10V
  16. T1, T2, T3, T4 = BC148
  17. T5 = SL100
  18. D1, D2, D3 = 1N4001
  19. ZD1, ZD2 = 3.1V
  20. ZD3 = 9.1V
  21. SW1, SW2 = Push to on switch
  22. X1 = 230 primary AC primary to 18-0-18, 500mA secondary transformer
  23. OR
  24. (110 primary AC primary to 18-0-18, 500mA secondary transformer)
  25. RL1 = 12V, 200 Ω Double pole double throw
  26. M = Motor

Description

This is circuit schematic diagram of Electronics Motor Controller Based on Transistor that can help you to build electronic motor controller. The main component in this circuit are transistors. 

According Electronicsproject site that also published this circuit describe that the power supply is given by pressing switch SW1 it shots the N/O contact of relay RL­1 which gives supply to the circuit. The current through resistor R8 gives the base current to transistor T5. Where transistor T1, T2 and T3 from the over and under-voltage cut-offs. Here the transistor T4 on when over or under voltage is given to transistor T3.

For avoiding noise capacitor C2 with resistor R10 form a loss-pass filter and also give sufficient time delay. Here the resistor network (R11, R12, VR1) are used as current sensor. Where Diode D3 is as rectifier and capacitor C1 is used as noise filter of switching circuit.

Now, you can read more about this Circuit Schematic Diagram Electronics Motor Controller Based on Transistor circuit schematic diagram, from original source using link here.


Thank you for your coming here in www.elcohow.com site, we hope the article above will help you to know more about your eletronic circuit design software and other. Please comment here when you want to share and other. Thank you.


0 comments:

Post a Comment